System Commissioning

Purpose of Commissioning

WISE Group uses system commissioning to make sure your system is installed correctly, set up as planned, and ready to use.

Commissioning is a controlled and structured activity. It ensures reliable operation, supports system documentation, and helps avoid problems later in the system’s life.

Commissioning Is Not Always a Single Visit

Commissioning can happen in several stages, depending on your project.

The first round of commissioning might happen at a shipyard or integration site. Later, a final visit is often needed at the system’s actual location. This is typical for setups like FPSOs, where some checks must be done during real operations.

Important Requirements Before Commissioning

System Power-Up

Do not power up the system before WISE Group staff arrive, unless you have written approval.

This way, our engineers can check everything before the system is powered up for the first time. These checks make sure wiring, connections, grounding, and safety features are all correct. If the system is powered too soon, problems might be missed and could cause delays or extra work later.

Sensor Installation and Handling

Please install and handle all sensors as described in the sensor documentation.

To keep the system working well, sensors need to be placed, sealed, and protected from the environment as instructed. If not, moisture can get in or measurements may be wrong. These problems might not show up right away after powering on.

What Happens During Commissioning

Commissioning usually starts with a review of the system and how it was installed. WISE Group engineers then check the setup before configuring and testing the system in a controlled setting.

During testing, we watch how the system works, check alarms and data, and fix any problems we find. It’s normal to find some faults, especially the first time the system is powered up. This is part of the commissioning process.

When the system works as it should, we finish the commissioning records and get the system ready for the next acceptance step.

Final Site Visit: Final Commissioning, SAT, Training and MRU Verification

For some installations, a final site visit is required at the operational location. This visit typically includes:

• Final commissioning, where the system is verified under real operating conditions.

• SAT (System Acceptance Test), which shows the system meets the agreed requirements at the final site.

• MRU verification, where we check motion sensors while the vessel is moving. This is especially important for floating systems and for meeting requirements like CAP 437.

• Training, where we show your team how to use the system, understand alarms, and handle basic troubleshooting.

This visit is a planned part of delivering your system and is not just a repeat of earlier commissioning steps.

Responsibility Boundaries

Shipyard or onboard staff often handle most of the mechanical and electrical installation.

WISE Group takes care of the final checks, commissioning, SAT, MRU verification, and training to make sure everything works correctly and is properly documented.

Warranty Considerations

The system warranty depends on correct installation, handling, and having WISE Group carry out commissioning and acceptance.

If the system is powered up too soon, wired incorrectly, or sensors are not installed correctly, the warranty may not cover the problems. Fixing these issues could mean extra costs.

After Commissioning and Acceptance

After commissioning and any final site work, your system starts normal operation. We finish the paperwork and provide ongoing support as agreed.

Key Takeaway

Commissioning and final acceptance are step-by-step processes that help ensure your system operates reliably in its intended environment and meets all documentation and regulatory requirements.

Sticking to the agreed process and requirements is the best way to ensure a smooth handover and long-lasting system performance.